Acura MDX SUV Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Came from this older thread:


But no answer after a few days so thought I would repost in a separate thread.

Does anyone know where I can buy the connector with 2 wires attached that connects to the factory ADS wiring harness? I live in an area with a lot of rain and I want to buy 4 of the connectors and solder a resistor to each with heatshrink over each of the two leads and a larger heatshrink over the resistor + glue to seal the whole package and protect it. I would like to assemble and test this part before removing the wheels so it's ready to go for when I get to that part. Here's what the connector looks like:

Finger Water Automotive tire Thumb Nail




I might be able to reuse the connector from the bad strut, but I'd prefer to use a new connector and wiring if possible so that I can make and test the resistor setup ahead of installation.

Like what this guy did:


Look like he attached an audio coil resistor. Not sure if he mentioned the connector part type in the video. I don't speak Russian.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #3 ·
Not sure if you can just buy the connect by itself. You can get the entire wiring harness for each damper pn# 51610-STX-A02
It looks like a standard automotive connector. Similar to this:

 
1 - 3 of 3 Posts
Top