Acura MDX SUV Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hello All,

Thanks for reading. I have a 2017 MDX and wanted to have vossen on it. Spoke with vossen over chat and the rep told me that the only available and recommended option for the CV7 would now be 22x9 Et30. I know that et38 would fit nicely but how about et30 ? I just hate it when the wheels stick out of the fender like a hot rod :) (BTW, the ET38 does not exist on the 5x120 pattern as I was told by Vossen)

Any comments would be appreciated.
Thanks
Bo
​​​​​​​
 

·
Registered
Joined
·
2,926 Posts
See some examples here: http://www.mdxers.org/forums/showthread.php?t=108690

30 should be OK, esp since you're going 22s so profile will be short and will curve tire in rather than bulging out. 35 is also where i would generally consider limits so 5mm more isnt that bad. Are you sure you don't want a wider rim?


Also, you can negative camber (just about -1 or -2) to make it look and handle a bit better.

Sent from my Pixel using Tapatalk
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top