Acura MDX SUV Forums banner

1 - 1 of 1 Posts

169 Posts
Discussion Starter #1
Has anyone done this before? Any tips/tricks? It seems pretty straightforward, but couldn't find anything on the forum or web re: a DIY. The windshield replacement guy bent the plastic back enough so there are gaps where the rubber should seal against the windshield. I assume water getting down there is not good or is there some design aspect I am missing that will channel it to a safe location if it slips under the cowl?

I'm going to try and get him to reimburse the cost of the new cowl, but if you want something done right you need to do it yourself.

Can anyone help confirm the part as well (74200-STX-A00)? I think it is this...

74200-STX-A00 - Genuine Acura Cowl Top Assy., FR.

and it looks to come with the rubber seal/glazing too. Any other complementary clips or parts I should consider?
1 - 1 of 1 Posts