Acura MDX SUV Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I have a 2016 MDX that I getting ready to change the timing belt on. I have the tool I used to hold the crankshaft on my 2004 accord V6 when I did its timing belt. Is this the same tool? I believe the Accord tool is referred to as a 50mm and I am concerned I need a 65mm tool for the MDX but can't find any 65mm tools listed. Thanks for the help.
 

·
Registered
Joined
·
3,338 Posts
You can always guetto remove it... Works.every.single.time.
 

·
Registered
Joined
·
962 Posts
I successfully used an IR 244 impact gun with 150 psi air pressure to remove the bolts many times in my shop. I had the Honda tool, but the gun was faster. The problem comes when tightening the bolt. To be accurate you need the holder.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #7 (Edited)
Does anyone know if there is an aftermarket tool that fits the MDX? The one I bought for my Honda was like $30 and worked fine. It seems like the 65mm one is much less common than the 50mm which is listed everywhere.

Thanks.
 

·
Registered
Joined
·
2,795 Posts
Huh.. how does that occur when the service instructions call for 65mm... Lol

Sent from my Pixel using Tapatalk
 
1 - 9 of 9 Posts
Top