Acura MDX SUV Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
13 Posts
If anyone has a BSM that is starting to fall off here is a good trick.Go to a local parts store that carries 3M products for automotive collision repair.Ask them for a bottle of 3M Adhesion Promoter for body moldings.Clean the affected part and the surface it sits on and apply a small amount of the 3M Adehesion Promoter following the directions supplied with it then reattach the BSM molding.Let it sit for a bit and it will be permanent.I have used this stuff many times and after the repair I think you will nedd a crowbar and a lot determination to remove the molding.Jens
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top