Acura MDX SUV Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi everyone. I am brand new to the forum as I recently purchased a 2005 MDX. I am trying to replace the cv axle on the front passenger side however I cannot get the shaft removed from the intermediate shaft. I have been prying and pulling and actually removed the axle at the boot by accident. I watched a bunch of videos on this however I don't really see a good place to pry from. The 1st pic is the current situation. The second pic is from under the car. Should I pry against the rusty portion of the axle or the silver ring I have created a small gap in. It seems the lip of the silver ring is bending. If I grab the piece that's there it moves in and out about a 1/4 of an inch freely but is hung up. Any advice is appreciated.
 

Attachments

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top